Citizen BJ2115-07E Instruction Manual download pdf (Page 26)

4948

12. SETTING FUNCTION HAND AT “0” POSITION

(1) Set the watch to the Time mode or

Chronograph mode.

Turn the crown to loosen it and pull it

out to the second click stop position.

(2) Press button A or B to set the

function hand to the “0” position.

(3) Press the crown in to the normal

position and turn it until it is tightly

screwed against the case.

“0” position

Within ±15 graduations before/after

the “0” point.

Adjusting position

* The aforementioned procedure is effectual only when the hand is located

within ±15 graduations before/after the “0” point. When the hand is located

outside the adjustable range, correct the “0” position of the hand referring to

“13. ALL RESET/ADJUSTING HAND POSITION”.

* If the watch has been left without any operation for 3 minutes or longer as the

crown is pulled to the second click stop position, the function hand does not

move regardless of button operation. If the watch falls into such the condition,

press the crown into the normal position and make a fresh start to adjust the

hand position.

* Before unscrewing and pulling out the crown, make sure that the crown is not

wet.

Automatic time correction function

If it takes 4 minutes or less to adjust the position of the function hand in

the Chronograph mode, the watch automatically sets the hour, minute and

second hands for the correct time immediately after the adjustment by the

automatic time correction function. Therefore, if adjustment is finished within

4 minutes, the watch has no need of manual time correction. However, if the

crown is turned during adjustment, the watch will not indicating a correct

time. If adjustment is not complete within 4 minutes, you will need to not only

adjust the “0” position of the second indicator (function hand) in the

Chronograph mode but also to set the correct time.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Citizen BJ2115-07E Instruction Manual Page 26