Citizen CT-S300 User Manual download pdf (Page 127)

— 122 —

ESC L

[Function] Selecting PAGE MODE

[Code] <1B>H<4C>H

[Outline] Switches from STANDARD MODE to PAGE MODE.

[Caution] • This command is only effective if it entered at the beginning of a line.

• This command is not effective if it is entered when in PAGE MODE.

• STANDARD MODE is restored when printing specified by FF is finished or when

ESC S is issued.

• The character mapping start position will be the point specified by ESC T in the

print area specified by ESC W.

• The commands listed below, which have separate settings for PAGE MODE and

STANDARD MODE, are changed to the settings for PAGE MODE use.

(1) Spacing setting: ESC SP, FS S

(2) Line feed width setting: ESC 2, ESC 3

• The following commands are valid only in PAGE MODE.

(1) ESC V Specifying/canceling 90°-right-turned characters.

(2) ESC a Aligning the characters.

(3) ESC { Specifying/canceling the inverted characters.

(4) GS L Setting the left margin.

(5) G3S W Setting the print area width.

• The following commands are disabled in PAGE MODE.

(1) GS ( A Executes test printing.

(2) FS P Prints NV memory bit image.

(3) FS q Defines NV memory bit image.

(4) GS v 0 Prints raster bit image.

• ESC @ restores STANDARD MODE.

[See Also] Appendix 4.1.4 “Example of using PAGE MODE”

FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS W, GS \

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 157 158

No comments

Citizen CT-S300 User Manual Page 127