Citizen iDP-3210 User Manual download pdf (Page 52)

iDP3210 User’s Manual

CITIZEN

(13) Setting Horizontal Tab Position (ESC D n NUL)

Code : [1B]h + [44]h + n [00]h

*{0≤ n ≤ FF} Dta is described in Hex code.

Specifying a horizontal tab position.

•"n" indicates the no. of columns from the beginning to the horizontal tab position. At this time, n= set

position –1 is to be specified.

•The tab position is set at position where it is "character width x n" from the line beginning. The character

width, at this time, includes the rightward space amount. In double wide characters, it is made double of

the ordinary case.

•Tab positions can be specified are maximum 24. Specifying exceeding this is ignored.

•ESC D NUL clears all the set tab positions. Following clearing, horizontal tab command is ignored.

•Initial value is specified for each eight characters(9.17.25.33.41) of ANK characters.

(14) Specifying/canceling highlighting (ESC E n)

Code : [1B]h + [45]h + n

*{0≤ n ≤ FF} Data is described in Hex code.

Specifying/canceling the highlighted characters.

•"n" is valid only for the lowest bit (n0).

•Control by the lowest bit (n0) is shown as follows:

n0 Type

0 Canceling highlighting.

1 Specifying highlighting.

• This is effective to all characters.

• Dot configuration of a highlighted character includes one extra dot added at its side.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 72 73

No comments

Citizen iDP-3210 User Manual Page 52