Citizen GSX-190 Service Manual Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 272
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
PN 4237242C
3.2-3
INSTALLATION PROCEDURES
INITIAL SETUP
3
Connect the Printer
1. Determine which type of Printer(s) need to be installed.
r To install the standard Graphic Printer only, follow this procedure.
r To install the optional Ticket Printer or the optional Ticket Printer and the Graphic
Printer, go to Heading 3.4, OPTIONAL TICKET PRINTERS.
2. Connect the Printer cable between the Printer and the 25-pin parallel connector at the
back of the MD II (Figure 3.2-2.).
Figure 3.2-2 System Electrical Connections
3. Load paper into the Printer.
4. Set the Printer configuration for MD II use.
ATTENTION: The procedures for setting the configuration and the sequence of setting the
configuration and powering up the Printer depends upon the specific Printer. Refer to the
Printer manual for instructions on how to set the Printer’s configuration.
The Printer must be an Epson-compatible Printer, but should be set for IBM
®
emulation since
some characters are used from the IBM character set. Paper size must be set to 8.5 in. by
11 in. Other settings or options can be set to the customers’ preference. If the site is using the
CITIZEN GSX-190 printer, use the configuration settings in Figure 3.2-3.
5. If you have not plugged the Printer into an available power source and turned the Printer
on, do so now.
7242035B
PRINTER
MD II
POWER LINE
CORD (AC DILUTER
TO ANALYZER)
25-PIN PARALLEL
CONNECTOR
SERIAL
PORT 2
AC
POWER
CABLE
TO POWER
SOURCE
CENTRONICS
PARALLEL
PRINTER
CABLE
SERIAL
PORT 1
C
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 271 272

Comments to this Manuals

No comments