- 132 -
2.2.15 Special Commands
ESC n n
[Function] Setting the remaining amount of printout
[Code] <1B>H<6E>H<n>
[Range] 0≦n≦255 (“n” in the 3rd byte denotes this command.)
[Outline] • This command sets the remaining amount of printout after detecting paper near-end1.
• “n” is set in cm.
[Caution] • If the paper near-end (PNE) sensor is disabled, this command has no function.
• The set value and the remaining amount of printout are not cleared by the initialize
command (ESC @).
• If a value lower than the preset value is set during PNE detection, the printer may
stop printing.
• The set value remains valid until the printer is restarted or a new value is set.
[Default] n = 150 (150 cm)
[Sample Program]
LPRINT CHR$(&H1B); CHR$(&H6E); CHR$(100);
ESC Y n1 n2
[Function] Specifying length of paper feed after black mark detection
[Code] <1B>H<59>H<n1><n2>
[Range] 0n1≦≦255
0n23≦≦
Length of paper feeding=(n1+256×n2)×1/203 inch
[Outline] • This command specifies length of paper feeding after detecting black mark for 0 mm
to 127.875 mm by (n1+256×n2)×1/203 inch
• If length of paper feed is specified by this command and when printer receives GS+S
(Black mark detection command), printer feeds paper for the specified length after
detecting black mark.
[Default] n=0
Comments to this Manuals