- 71 -
GS V m … (1)
GS V m n … (2)
[Function] Cutting the paper
[Code] (1)<1D>H<56>H<m>
(2)<1D>H<56>H<m><n>
[Range] (1)0≦m≦1, 48≦m≦49
(2)65 m≦≦66
[Outline] Performs the specified paper cutting.
m Function
0,48 Full cut
1,49 Full cut
65 Paper feed by “cut position + basic calculation pitch” and full cut
66 Paper feed by “cut position + basic calculation pitch” and full cut
[Caution] • In STANDARD MODE, this command only works when it is entered at the beginning of
a line.
• Control to make the length of cut paper less than 10 mm is not executed.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n ≠0, the paper is fed
by “n×basic calculation pitch” inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
• The paper feed amount is calculated with the vertical basic calculation pitch (y). A
fraction resulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
Comments to this Manuals