Citizen PPU-700II Specifications download pdf (Page 149)

- 147 -

GS P x y

[Function] Specifying the basic calculation pitch

[Code] <1D>H<50>H<x><y>

[Range] 0 x 255≦≦ , 0 y≦≦255

[Outline] • This command sets the horizontal basic calculation pitch to approx. 25.4/x mm (1/x

inches), and the vertical basic calculation pitch to approx. 25.4/y mm (1/y inches).

• If x = 0, the horizontal basic calculation pitch is reverted to the default value.

• If y = 0, the vertical basic calculation pitch is reverted to the default value.

[Caution] • The horizontal direction is defined as the direction perpendicular to the paper feed,

and the vertical direction is defined as the paper feed direction.

• In STANDARD MODE, the following parameters are used regardless of the character

orientation (e.g. inverted or 90°-right-turned).

(1) Commands using x: ESC SP, ESC $, ESC ＼, FS S, GS L, GS W

(2) Commands using y: ESC 3, ESC J

• In PAGE MODE, the parameters used depend on the character orientation, as follows:

(1) If the start point specified by ESC T is the top left or bottom right (The

characters are mapped in the direction perpendicular to the paper feed):

• Commands using x: ESC SP, ESC $, ESC W, ESC ＼, FS S

• Commands using y: ESC 3, ESC J, ESC W, GS $, GS ＼

(2) If the start point specified by ESC T is the top right or bottom left (The

characters are mapped in the paper feed direction):

• Commands using x: ESC 3, ESC J, ESC W, GS $, GS ＼

• Commands using y: ESC SP, ESC $, ESC W, ESC ＼, FS S

• This command does not affect any other values that are already set.

• If calculations made in combination with another command generate fractions, the

fractions are corrected with the minimum pitch of the mechanism, and the remainder

is omitted.

[Default] x＝203, y＝203

[See Also]

Appendix 4.1 “Explanation on PAGE MODE”

ESC SP

, ESC $, ESC 3, ESC J, ESC W, ESC ＼, GS $, GS L, GS W, GS ＼

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 199 200

No comments

Citizen PPU-700II Specifications Page 149