Citizen PPU-700II Specifications download pdf (Page 185)

- 183 -

Byte Mode

In this mode, data is transferred between the printer and the host through the procedure described

below. The steps beginning from (1) are applicable when the Negotiation phase has switched to the

Host Busy Data Available phase. If the Negotiation phase has switched to the Host Busy Data Not

Available phase, the procedure starts at step (9).

(1) After the negotiations for the entry into the Byte mode are complete, the host indicates that it is

ready to receive data from the printer. This is indicated by switching the data bus to a

high-impedance state and setting HostBusy (nAutoFd) to Low. (Events 14 and 7)

(2) The printer places communication data on the data bus. (Event 15)

(3) The printer sets PtrClk (nAck) to Low. (Event 9)

(4) The host sets HostBusy (nAutoFd) to High to indicate that it has latched data and received the

signal in Event 9. (Event 10)

(5) The printer must set the four status lines as shown below. (Event 13)

• PtrBusy (Busy) : Returned to the status given in the Forward mode.

• nDataAvail (nFault) : Set to Low if there is data to be sent.

• AckDataReq (PError) : Set to Low if there is data to be sent.

• Xflag (Select) : Set to the status given during the last negotiation (i.e., set to Low).

(6) The printer sets PtrClk (nAck) to High (Event 10) and ends the Byte handshake. (Event 11)

(7) The host indicates that it has succeeded in receiving the data. This is indicated by setting

HostClk (nStrobe) to Low (Event 16) and then to High. (Event 17)

(8) Events 10 and 16 may occur simultaneously, and Events 7 and 17 may occur simultaneously.

(Such as when HostBusy and HostClk are used together.)

(9) After transferring one byte of data, the printer signals to the host whether it has more data to

transfer. When there is no more data to be received by the host from the printer, the host

chooses one of three status selections:

1. Performing Termination and returning to the Compatibility mode.

2. Remaining in the Host Busy Data Not Available phase.

3. Setting HostBusy (nAutoFd) to Low and moving to the Reverse Idle phase. (Event 7)

(10) When more data is to be received from the printer, the host chooses one of three status

selections:

1. Setting HostBusy (nAutoFd) to Low and indicating that the host is ready to receive.

2. Remaining in the Host Busy Data Available phase.

3. Performing Termination and returning to the Compatibility mode.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 199 200

No comments

Citizen PPU-700II Specifications Page 185